Recorded Song Mixer Settings - Casio CT-X5000 User Manual

11.
To exit the Step Input Mode, press
cs REGISTRATION [1].
This causes the [STEP] indicator to disappear.

Recorded Song Mixer Settings

You can configure the mixer settings of each part of the
system track and the solo tracks of a recorded song.
To configure the mixer settings of a recorded
song
1.
Perform the procedure under "To enter the
Song Editing Mode" (page EN-99).
2.
Long-press 9 PART (MIXER) until the
[MIXER] indicator appears.
• To configure the mixer settings of the system track,
configure the settings of each part of the SONG
SYSTEM part group. To configure the mixer settings of
a solo track, configure the settings of each part of the
SONG SOLO part group. For information about the
parts within a part group, see "List of Parts for Each
Mixer Part Group" (page EN-65).
3.
Select the part group whose mixer settings you
want to configure.
(1) Press 9 PART and confirm that the lamp to the left
of the button is lit.
(2) Use bn [–] and [+] to select the part group (SONG
SYSTEM or SONG SOLO) whose settings you want
to configure.
(3) Press 9 PART and confirm that the lamp to the left
of the button is unlit.
4.
Use the [1] (V) and [3] (W) bm number keys
to select the part whose settings you want to
configure with the mixer.
Using the MIDI Recorder to Record
5.
Use the [2] (w) and [5] (q) bm number keys to
display the menu item you want to change.
• Initial default setting values are indicated by an
asterisk (*).
Item Name
Description
(Display)
Part On/Off Specifies on/off for the
(Part) selected part.
Tone (Tone) Specifies the tone of the
selected part.
Volume Adjusts the volume level of
(Volume) the selected part.
Pan (Pan) Specifies the stereo pan
position of the selected
part. 0 indicates the center,
while a smaller value shifts
to the left and a larger value
shifts to the right.
Coarse Tune Shifts the pitch of the part in
(Coarse) semitone steps.
Fine Tune Fine tunes the pitch of the
(Fine) part in cent units.
Bend Range Adjusts how much the
(Bend Rng) sound changes when the
pitch bend wheel is rotated.
Reverb Send Specifies how much reverb
(Rev Send) is applied to the selected
part.
Chorus Send Specifies how much chorus
(Cho Send) is applied to the selected
part.
Delay Send Specifies how much delay
(Dly Send) is applied to the selected
part.
6.
Use bn [–] and [+] or the bl dial to change the
setting value.
7.
When mixer settings are the way you want,
press the [4] (EXIT) bm number key.
Settings
On*, Off
1 to 900
0 to 127*
–64 to 0* to 63
–24 to 0* to 24
–99 to 0* to 99
0 to 2* to 24
0 to 40* to 127
0* to 127
0* to 127
EN-111