Casio CT-X5000 User Manual page 31

Controlling Sounds
To connect a pedal to the fo PEDAL1 jack
1.
Connect a pedal to the fo PEDAL1 jack.
2.
Press bk FUNCTION.
3.
Use the [1] (V) and [3] (W) bm number keys
to display "Cntrller", and then press [6]
(ENTER).
4.
Use the [1] (V) and [3] (W) keys to display
"Pedal", and then press [6] (ENTER).
This displays "Pd1Efect". This is the Pedal 1 function
selection mode.
5.
Use bn [–] and [+] or the bl dial to change the
setting value.
• For details about the function that is assigned by each
setting value, refer to the "Pedal Function List" (page
EN-31).
6.
Turn pedal effects on or off for each keyboard
part* as required.
(1) Use the [1] (V) and [3] (W) bm number keys to
display "Pd1Enabl".
(2) Press the [6] (ENTER) bm number key.
(3) Use the [1] (V) and [3] (W) keys to display the
part whose setting you want to change.
(4) Use bn [–] and [+] to switch between on and off.
• The pedal effect is applied to parts that are turned
on, and not applied to parts that are turned off.
• The Auto Harmonize (page EN-52) sound
depends on the UPPER 1 part setting.
7.
When the setting is the way you want, long-
press the [4] (EXIT) bm number key to exit the
setting screen.
* See "Sounding Multiple Tones (Layer and Split)" (page
EN-19).
EN-30
To connect a pedal to the fp PEDAL2/
EXPRESSION jack
1.
Connect a pedal to the fp PEDAL2/
EXPRESSION jack.
2.
Press bk FUNCTION.
3.
Use the [1] (V) and [3] (W) bm number keys
to display "Cntrller", and then press [6]
(ENTER).
4.
Use the [1] (V) and [3] (W) keys to display
"Pedal", and then press [6] (ENTER).
5.
Use the [1] (V) and [3] (W) keys to display
"Pd2 Type".
6.
Use bn [–] and [+] or the bl dial to change the
setting value.
To use this type of pedal:
Foot switch pedal
Expression pedal (Type 1 polarity*) 2 ExpType1
Expression pedal (Type 2 polarity*) 3 ExpType2
* For details, see "Connectable Expression Pedals" (page
EN-32).
• If a pedal does not work correctly after configuring
settings, it could mean that the connected pedal is not
compatible with the "Pd2 Type" setting above. Try
changing the "Pd2 Type" to a different setting and see
if this results in correct operation.
Select this setting:
1 Foot Sw