Honeywell 6824 User Manual page 18

Chapter 1 – About the Printer
Error State Descriptions (continued)
Error Type
Internal temperature error
Printhead jam or carrier
error
System error
EEPROM error
RAM error
Font error
8
Indicator Behavior
READY: On
FAULT: Blinking every half second
TRACTOR: Off
READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: On
READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: Off
READY: On
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
READY: Off
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
READY: Blinking every half second
FAULT: Blinking every half second
TRACTOR: Blinking every half
second
Description and Recovery
Internal printer temperature is too hot or too cold
(less than -40 °C or more than 150 °C). To
recover, turn off the printer.
Either the printhead cannot find the home
position when you turn on the printer, or the
printhead reaches the home position
unexpectedly. To recover, turn off the printer.
An illegal printer logic condition was detected. To
recover, turn off the printer.
An EEPROM checksum error was detected. To
recover, turn off the printer.
RAM read/write check failed. To recover, turn off
the printer.
Font check code error was detected. The printer
indicators show this error state for 7 seconds,
and then the printer enters initial program
loading mode. In this mode, the printer will not
function normally.
For more information, see "Recover From a Font
Error."
6824 Mobile Full Page Printer User Manual