Crosscutting Full-Size Panels; Crosscutting Smaller Panels; Crosscutting Using Rip Fence As Cut-Off Gauge - Grizzly G0764 Owner's Manual

Crosscutting Full-Size Panels

1.
Install crosscut fence in front mounting loca-
tion shown in Figure 113.
Front Mounting
Location
Figure 113. Crosscut fence mounting locations.
2.
Check to make sure fence is at 0°, and if
necessary, adjust it as described in Squaring
Crosscut Fence to Blade on Page 79.
3.
Adjust distance between crosscut fence and
blade (refer to Page 54 for further details).
4. Set either flip stop to the desired width of cut.
Note: Extend the crosscut fence slide if the
workpiece is more than 73".
5. Load workpiece onto table saw in forward
mounting location shown in Figure 110.
6. Take all necessary safety precautions, then
perform cutting operation.

Crosscutting Smaller Panels

1.
Install crosscut fence in rear mounting loca-
tion shown in Figure 110 and lock it in place.
2. Perform Steps 2 & 3 in Crosscutting Full-
Size Panels.
3.
Set either flip stop to the desired width of cut.
Note: Extend the crosscut fence slide if the
workpiece is more than 73".
Model G0764 (Mfd. Since 02/14)
Rear Mounting
Location
4. Load workpiece onto table saw in rear mount-
ing location, shown in Figure 113. If neces-
sary, use edge shoe to secure workpiece to
sliding table.
5.
Take all necessary safety precautions, then
perform cutting operation.
Crosscutting Using Rip Fence as
Cut-Off Gauge
1.
Install crosscut fence in rear position of
crosscut table, as illustrated in Figure 112 on
Page 58.
2. Perform Steps 2 & 3 in Crosscutting Full-
Size Panels.
3.
Set rip fence to desired width of cut.
4.
Slide leading end of rip fence behind front
edge of blade (see Figure 114 for an exam-
ple).
Important: This step is critical to reducing
the risk of blade binding and kickback.
Front Edge
of Blade
Figure 114. Example photo of correct rip fence
position when using it as a cut-off gauge
(blade guard removed for clarity).
5. Load workpiece onto table saw and against
rip fence. The setup should look similar to
Figure 114.
6.
Take all necessary safety precautions, then
perform cutting operation.
Rip Fence
Leading Edge
of Rip Fence
-59-