Dust Collection - Grizzly G0764 Owner's Manual

Dust Collection

This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
Minimum CFM at 5" Dust Port:
Minimum CFM at 2 ⁄
1
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection hoses:
1. Fit 5" dust hose over dust port on rear side of
cabinet, as shown in Figure 59, and secure
with hose clamp.
Figure 59. 5" dust hose attached to dust port.
Model G0764 (Mfd. Since 02/14)
615 CFM
" Dust Port: 150 CFM
2
2. Fit 2 ⁄ " dust hose over dust port on blade
1
2
guard, as shown in Figure 60, then secure it
in place with a hose clamp.
Important: Secure 2
guard arm (e.g., with cable tie) so that it will
not become entangled with workpiece or
blade during operations.
Cable Tie
Figure 60. 2 ⁄ " dust hose attached to blade
1
2
guard.
3. Connect 5" and 2 ⁄
1
then attach it to a single dust collection
branch line.
4. Tug on dust hoses to make sure they do not
come off. A tight fit is necessary for proper
performance.
⁄ " dust hose to upper
1
2
Hose
Clamp
" dust hoses to a Y-fitting,
2
-37-