Setting Up Crosscut Fence; Positioning Crosscut Fence - Grizzly G0764 Owner's Manual

Setting Up Crosscut
Fence
Before using the crosscut fence to perform
cutting operations, it must be setup properly.
This includes positioning the crosscut fence on
the crosscut table, adjusting the support bar,
adjusting the crosscut fence distance from the
blade, and positioning the crosscut table along
the sliding table.

Positioning Crosscut Fence

The crosscut fence can be mounted in the front
or rear position (see Figure 92) depending upon
the size of the workpiece and which position will
provide the safest operation. The support bar
is adjusted accordingly for maximum workpiece
support.
Front
Position
Crosscut
Table
Crosscut
Table
Rear
Position
Figure 92. Crosscut fence front and rear table
mounting positions.
Whenever the crosscut fence is moved between
the front and rear positions, you must verify the
fence is square to the blade, and the 0° stop bolts
are properly adjusted before using the fence.
Refer to Squaring Crosscut Fence to Blade on
Page 79 for further details.
Model G0764 (Mfd. Since 02/14)
Support
Bar
Support
Bar
The support bar can also be installed in either the
inside or outside positions (see Figure 93).
Crosscut
Table
Crosscut
Table
Crosscut
Table
Outside
Position
Figure 93. Inside and outside support bar
positions.
To position crosscut fence:
1.
DISCONNECT MACHINE FROM POWER!
2.
Unthread and remove knob bolts shown in
Figure 94.
Knob Bolts
Figure 94. Locations of knob bolts securing
crosscut fence.
Inside
Position
-53-