Crosscutting - Grizzly G0764 Owner's Manual

Crosscutting

The Model G0764 can crosscut full-size pan-
els with the fence in the front or rear position,
although it is easier to load full-size panels with
the crosscut fence mounted in the front position
(see Figure 110).
Workpiece
Figure 110. Crosscut with fence mounted in
front position.
Mounting the crosscut fence in the rear position
(Figure 111) gives greater stability for crosscutting
smaller panels.
Edge Shoe
Workpiece
Crosscut Fence
Figure 111. Crosscut with fence mounted in rear
position.
The edge shoe (see Figure 111) is used to
stabilize the front end of the workpiece when
otherwise unsecured.
-58-
When set up properly, the crosscut fence can
support workpieces while using the rip fence as a
cut-off gauge, as shown in Figure 112.
Support Edge
Bar Shoe
Workpiece
Crosscut Fence
Figure 112. Crosscutting using the rip fence as
a cut-off gauge.
Determine which cutting operation will be best
suited for the workpiece to be crosscut.
— If you will be crosscutting full-size panels,
then skip ahead to Crosscutting Full-Size
Panels.
— If you will be crosscutting smaller panels,
then skip ahead to Crosscutting Smaller
Panels.
— If you will be crosscutting workpieces using
the rip fence as a cut-off gauge, then skip
ahead to Crosscutting Using Rip Fence
as Cut-Off Gauge.
To understand how to move the crosscut table,
read Positioning Crosscut Table Along Sliding
Table on Page 55.
Model G0764 (Mfd. Since 02/14)
Rip
Fence