System Installation; Installing The Cisco Sce 8000 Platform; Cisco Sce 8000 Connectivity - Cisco SCE 8000 Installation Manual

3

System Installation

This chapter describes the system installation of the Cisco Service Control solution.

Installing the Cisco SCE 8000 Platform

To install the Cisco SCE 8000 platform, complete the following steps. (For more information, see the Cisco SCE 8000 10GBE
Installation and Configuration Guide or the Cisco SCE 8000 GBE Installation and Configuration Guide.)
Install the Cisco SCE platform on the rack.
Step 1
Step 2 Connect the chassis ground and the power.
Connect the CON port to a local terminal. Configure the initial setup parameters as necessary. (See the
Step 3
Configuration of the Cisco SCE 8000 Platform" section on page
Connect the MNG port to the local LAN.
Step 4
Step 5 Cable the line ports. (See
various topologies).

Cisco SCE 8000 Connectivity

Table 1, Table 2, Table 3,
Note Receive-only topologies use only Receive fibers. these can be implemented by using either an optical splitter or a switch.
If a switch is used, it must support SPAN functionality that includes separation between ingress and egress traffic and
multiple SPAN ports destinations.
Table 1 Single-Link Inline Connectivity
Port
3/0/0
3/1/0
Table 2 Dual-Link Inline Connectivity
Port
3/0/0
3/1/0
3/2/0
3/3/0
Table 3 Cascade Connectivity
This port on Cisco SCE 8000 #1
3/0/0
3/1/0
3/2/0 (cascade port)
the"Cisco SCE 8000 Connectivity" section on page 11
Table 4, and Table 5 summarize Cisco SCE 8000 connectivity for the basic topologies.
Link
Link 0
Link 0
Link
Link 0
Link 0
Link 1
Link 1
31).
Connects to...
Subscriber-side network element
Network-side network element
Port 3/3/0 on Cisco SCE 8000 #2
for a summary of proper cabling for
Side
Subscribers
Network
Side
Subscribers
Network
Subscribers
Network
"Initial
11