Xstatus Call [1 - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction
xStatus Call [1..n] Duration
Shows the duration of a call (in seconds). You can run the command xStatus Call to find the call
identity.
Value space of the result returned:
<Integer>
Example:
xStatus Call 27 Duration
*s Call 27 Duration: 2354
** end
xStatus Call [1..n] SecurityStatus
Security status of a call represents the least of the security statuses of all the endpoints involved in
a CUCM call.
Value space of the result returned:
<Invalid/Unknown/NotAuthenticated/Authenticated>
xStatus Call [1..n] AnswerState
Indicates if a call is answered, ignored or has been automatically answered by a system.
Value space of the result returned:
<Unanswered/Ignored/Autoanswered/Answered>
Example:
xStatus Call AnswerState
*s Call 5 AnswerState: Answered
** end
xStatus Call [1..n] ModifyState
Shows the current state of a pending Call Modify operation. Not in use in this software version.
OutgoingModify: a request CallEscalate to Video is pending.
IncomingModify: a peer has requested to escalate the call to Video.
Idle: No Call Modify operation is pending.
Value space of the result returned:
<Idle/Outgoing/Incoming>
Example:
xStatus Call ModifyState
*s Call 11 ModifyState: Idle
** end
SX20 Codec API Reference Guide TC6.2, JULY 2013.
D14949.04
About the API xConfiguration
xStatus Call [1..n] DeviceType
123
xCommand
Indicates whether the remote system is a single endpoint or a MCU. Some Cisco endpoints (EX90,
C40, C60, C90, SX20) have built-in MCU capabilities.
Value space of the result returned:
<Endpoint/MCU>
Example:
xStatus Call DeviceType
*s Call 4 DeviceType: Endpoint
** end
API Reference Guide
xStatus xStatus Appendices
Copyright © 2013 Cisco Systems, Inc. All rights reserved.