Cisco TelePresence SX20 Codec Reference Manual page 59

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration SystemUnit ContactInfo Type
Choose which type of contact information to show in the status field in the upper left corner of the
main display and Touch controller. The information can also be read with the command xStatus
SystemUnit ContactInfo.
Requires user role: ADMIN
Value space: <Auto/None/IPv4/IPv6/H323Id/E164Alias/H320Number/SipUri/SystemName/
DisplayName>
Auto: Show the address which another system can dial to reach this system. The address depends
on the default call protocol and system registration.
None: Do not show any contact information in the status field.
IPv4: Show the IPv4 address as contact information.
IPv6: Show the IPv6 address as contact information.
H323Id: Show the H.323 ID as contact information (see the H323 Profile [1..1] H323Alias ID
setting).
E164Alias: Show the H.323 E164 Alias as contact information (see the H323 Profile [1..1] H323Alias
E164 setting).
H320Number: Show the H.320 number as contact information (only applicable if connected to a
Cisco TelePresence ISDN Link gateway).
SipUri: Show the SIP URI as contact information (see the SIP Profile [1..1] URI setting).
SystemName: Show the system name as contact information (see the SystemUnit Name setting).
DisplayName: Show the display name as contact information (see the SIP Profile [1..1] DisplayName
setting).
Example: xConfiguration SystemUnit ContactInfo Type: Auto
xConfiguration SystemUnit CallLogging Mode
Set the call logging mode for calls that are received or placed by the system. The call logs may then
be viewed via the web interface or using the xHistory command.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable logging.
On: Enable logging.
Example: xConfiguration SystemUnit CallLogging Mode: On
SX20 Codec API Reference Guide TC6.2, JULY 2013.
D14949.04
About the API xConfiguration xConfiguration
xConfiguration SystemUnit IrSensor
59
xCommand
Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them needs to
be enabled at the time. The IR sensor LED is located on the front of the codec and the camera and
flickers when an IR signal is received from the remote control.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at camera is
enabled. Otherwise, the IR sensor on the codec will be enabled.
Off: Disable the IR sensor on the codec.
On: Enable the IR sensor on the codec.
Example: xConfiguration SystemUnit IrSensor: Auto
API Reference Guide
xStatus Appendices
Copyright © 2013 Cisco Systems, Inc. All rights reserved.