Cisco TelePresence SX20 Codec Reference Manual page 106

Cisco TelePresence SX20 Codec
Contents Introduction
xCommand SystemUnit ReleaseKey RemoveAll
Removes all Release keys.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand SystemUnit ReleaseKey RemoveAll Confirm: Yes
*r ReleaseKeyResult (status=OK):
** end
xCommand SystemUnit AdminPassword Set
Set an administrator password to restrict access the codec. After a restart of the codec this
password also applies to the web interface.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 64>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
*r AdminPasswordSetResult (status=OK):
** end
xCommand SystemUnit Diagnostics Run
This command runs all self-diagnostics commands on the system.
Requires user role: ADMIN
Parameters:
ResultSet(o): <Alerts/All/None>
Example:
xCommand SystemUnit Diagnostics Run
*r DiagnosticsResult (status=OK):
** end
SX20 Codec API Reference Guide TC6.2, JULY 2013.
D14949.04
About the API xConfiguration
xCommand SystemUnit MenuPassword Set
xCommand SystemUnit MenuPassword Validate
106
xCommand xCommand
Set a menu password to restrict access to Administrator Settings menu. If you have a remote
control the password can also be set from the on screen menu. If you have a Cisco TelePresence
Touch controller the menu password is set from the command line interface.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 255>
Example:
xCommand SystemUnit MenuPassword Set Password:***********
*r MenuPasswordSetResult (status=OK):
** end
Validate that the supplied password is correct.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 255>
Example:
xCommand SystemUnit MenuPassword Validate Password:***********
*r MenuPasswordValidateResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2013 Cisco Systems, Inc. All rights reserved.