Table 1007 Program Pins - Honeywell CAS-100 Maintenance Manual

Program
Pin
PP RBP 6J Single Xpdr
PP RBP 6K Single RA
PP RBP 7A Airborne Audio Level # 1
PP RBP 7B Airborne Audio Level # 2
PP RBP 7C Airborne Audio Level # 3
PP RBP 7D Audio Advisory Discrete
PP RBP 7E Ground Display Mode
PP RBP 7F Display All Traffic
PP RBP 7G Cable Delay Sign
PP RBP 7H Cable Delay MSB
PP RBP 7J Cable Delay LSB
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Table 1007. Program Pins
Display Text Fault Description
One Transponder Program Pin shows how many
transponders are installed:
*O = Both Transponders Installed
*1 = One Transponder Installed
One Radio Altitude Program Pin shows how many
Radio Altimeters are installed:
*O = Both Altimeters Installed
*1 = One Altimeter Installed
Airborne Audio Level Program Pins find the speaker
and phones audio level output when the aircraft is
airborne by strapping one or more Airborne Audio
Level Program Pins to Program Pin Common RBP7K
(See NOTE)
Audio Advisory Discrete Program Pins show if there is
an interval in the Synthesizer Voice output when an
advisory is given:
*O = No Delay
*1 = 1 ± 0.2 second delay (an audio tone is output
prior to the issuance of a voice command)
Ground Display Mode Program Pin shows the correct
mode for TCAS when the aircraft is on the ground:
*O = TA Only mode (Sensitivity Level = 2, RAs
prevented)
*1 = Standby Mode (Sensitivity Level = 1)
Display All Traffic/Threat Program Pin calculates the
traffic that is shown:
*O = Display All Traffic
*1 = Display TA/RA Traffic Only
The Cable Delay Program Pins show the differential
interval between the top and the bottom antenna.
34-45-47
Page 1026
1 Dec 2003