Honeywell CAS-100 Maintenance Manual page 177

CAS-100 COLLISION AVOIDANCE SYSTEM
(d) Mode-S Address
To push the Select button when Mode-S Address is the Active Selectable Item on
the Input screen causes the Mode-S Address display screen to display. The Figure
1018 shows an example of the Mode-S Address screen. Line two shows the
hexadecimal address of transponder No. 1 received from XT Coordination No. 1
(pins RMP 14F and RMP 14G) ARINC 429 data bus (labels 275 and 276). If the
data words are not received, no address will be shown and that area of the screen
will stay blank.
Typical Mode S Transponder Display Screen
(e) Continuous Wave Interference
To push the Select button when the Continuous Wave (CW) Interference is the
Active Selectable Item on the Input Screen causes the CW Interference display
screen to be shown. The Figure 1019 shows an example of a CW Interference
display screen. Line two shows the external CW Internal. If the external CW
Interference is between -1 and 0, then NONE will be shown. GO BACK is the Active
Selectable Item.
Continuous Wave Interference Display Screen
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
MAINTENANCE MANUAL
Figure 1018
Figure 1019
34-45-47
Page 1036
1 Dec 2003