Displaying Standard Qos Information; Standard Qos Configuration Examples - Cisco Catalyst 2950 Software Configuration Manual

Chapter 29 Configuring QoS

Displaying Standard QoS Information

To display standard QoS information, use one or more of the privileged EXEC commands in
Table 29-9 Commands for Displaying QoS Information
Command
show class-map [class-map-name]
show policy-map [policy-map-name [class class-name]]
show mls qos maps [cos-dscp | dscp-cos]
show mls qos interface [interface-id] [policers]
show mls masks [qos | security]
show wrr-queue cos-map
show wrr-queue bandwidth
1. Available only on a switch running the EI.
2. Access control parameters are called masks in the switch CLI commands and output.

Standard QoS Configuration Examples

These examples are applicable only if your switch is running the EI.
Note
This section shows a QoS migration path to help you quickly implement QoS features based on your
existing network and planned changes to your network, as shown in
information:
•
•
78-11380-12
1
1
1
1
QoS Configuration for the Existing Wiring Closet, page 29-40
QoS Configuration for the Intelligent Wiring Closet, page 29-41
Purpose
Display QoS class maps, which define the match criteria to
classify traffic.
1
Display QoS policy maps, which define classification criteria for
incoming traffic.
Display QoS mapping information. Maps are used to generate an
internal DSCP value, which represents the priority of the traffic.
Display QoS information at the interface level, including the
configuration of the egress queues and the CoS-to-egress-queue
map, which interfaces have configured policers, and ingress
statistics.
Display details regarding the masks
ACLs.
Display the mapping of the CoS priority queues.
Display the WRR bandwidth allocation for the CoS priority
queues.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Displaying Standard QoS Information
Table
2
used for QoS and security
Figure 29-5. It contains this
29-9:
29-39