Cisco Catalyst 2950 Software Configuration Manual page 36

Features
Table 1-1
Switch
Catalyst 2950T-48-SI
Catalyst 2955C-12
Catalyst 2955S-12
Catalyst 2955T-12
1. SI = standard software image
2. EI = enhanced software image
Certain Cisco Long-Reach Ethernet (LRE) customer premises equipment (CPE) devices are not
supported by certain Catalyst 2950 LRE switches. In
the switch; No means that the CPE is not supported by the switch.
Table 1-2
LRE Devices
Cisco 575 LRE
CPE
Cisco 576 LRE 997
CPE
Cisco 585 LRE
CPE
This section describes the features supported in this release:
Note Some features require that you have the EI installed on your switch. For a list of the switches that support
the EI, see
Ease of Use and Ease of Deployment
•
•
•
•
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
1-2
Switches Supported (continued)
LRE Switch and CPE Compatibility Matrix
Catalyst 2950ST-8 LRE
switch
Yes
No
Yes
Table 1-1, or see the release notes for this release.
Express Setup for quickly configuring a switch for the first time with basic IP information, contact
information, switch and Telnet passwords, and Simple Network Management Protocol (SNMP)
information through a browser-based program.
User-defined Smartports macros for creating custom switch configurations for simplified
deployment across the network.
Embedded device manager GUI for configuring and monitoring a single switch through a web
browser. For information about launching the device manager, see the getting started guide. For more
information about the device manager, see the switch online help.
Network Assistant application for
Simplifying and minimizing switch and switch cluster management from anywhere in your
–
intranet.
Software Image
SI
EI
EI
EI
Table 1-2, Yes means that the CPE is supported by
Catalyst 2950ST-24 LRE
switch
Yes
No
Yes
Chapter 1 Overview
Catalyst 2950ST-24 LRE 997
switch
No
Yes
No
78-11380-12