Understanding Cross-Stack Uplinkfast - Cisco Catalyst 2950 Software Configuration Manual

Chapter 15 Configuring Optional Spanning-Tree Features
Figure 15-3
Switch A
(Root)
If Switch C detects a link failure on the currently active link L2 on the root port (a direct link failure),
UplinkFast unblocks the blocked port on Switch C and transitions it to the forwarding state without
going through the listening and learning states, as shown in
approximately 1 to 5 seconds.
Figure 15-4
Switch A
(Root)

Understanding Cross-Stack UplinkFast

Cross-stack UplinkFast (CSUF) provides a fast spanning-tree transition (fast convergence in less than
1 second under normal network conditions) across a stack of switches that use the GigaStack GBIC
modules connected in a shared cascaded configuration (multidrop backbone). During the fast transition,
an alternate redundant link on the stack of switches is placed in the forwarding state without causing
temporary spanning-tree loops or loss of connectivity to the backbone. With this feature, you can have
a redundant and resilient network in some configurations. You enable CSUF by using the spanning-tree
stack-port interface configuration command.
CSUF might not provide a fast transition all the time; in these cases, the normal spanning-tree transition
occurs, completing in 30 to 40 seconds. For more information, see the
Convergence" section on page
78-11380-12
UplinkFast Example Before Direct Link Failure
L1
L2
Blocked port
Switch C
UplinkFast Example After Direct Link Failure
L1
L2
Link failure
Switch C
15-7.
Understanding Optional Spanning-Tree Features
Switch B
L3
Figure
Switch B
L3
UplinkFast transitions port
directly to forwarding state.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
15-4. This change takes
"Events that Cause Fast
15-5