G709 Otu Report Disable - Cisco ASR 9000 Series Command Reference Manual

Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router

g709 otu report disable

To disable the logging of selected Optical Channel Transport Unit (OTU) alarms to the console for a DWDM
controller, use the g709 otu report disable command in DWDM configuration mode. To return to the default
state, use the no form of this command.
g709 otu report {bdi| fecmismatch| iae| lof| lom| los| sd-ber| sf-ber| tim} disable
no g709 otu report {bdi| fecmismatch| iae| lof| lom| los| sd-ber| sf-ber| tim} disable
Syntax Description
bdi
fecmismatch
iae
lof
lom
los
sd-ber
sf-ber
tim
Command Default
Reporting is enabled for all keywords.
Command Modes
DWDM configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Backward defect indication reporting status.
FEC mismatch alarm reporting status.
Note
Incoming alignment error reporting status.
OTU loss of frame reporting status.
Loss of multiple frame reporting status.
Loss of signal reporting status.
SM bit error rate (BER) is in excess of the signal degradation BER threshold.
SM BER is in excess of the signal failure BER threshold.
Trace Identifier Mismatch reporting status.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
FEC mismatch alarm is
deprecated.
Modification
This command was introduced.
g709 otu report disable
Release 5.3.x
17