Lacp Churn Logging - Cisco ASR 9000 Series Command Reference Manual

lacp churn logging

lacp churn logging
To configure the parameters for LACP churn detection, enter the lacp churn loggin command in interface
configuration mode. To return to the default, use the no form of the command.
lacp churn logging{actor| both| partner}
no lacp churn logging{actor| both| partner}
Syntax Description
actor
both
partner
Command Default
The parameters for churn detection are not configured.
Command Modes
Interface configuration (config-if)
Command History
Release
Release 5.1.3
Task ID
Task ID
bundle
Examples The following example shows how to configure the LACP churn detection on a partner router:
RP/0/RSP0/CPU0:router# configure terminal
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100
RP/0/RSP0/CPU0:router(config-if)# lacp churn logging partner
The following example shows how to configure the LACP churn detection on both actor and partner routers:
RP/0/RSP0/CPU0:router# configure terminal
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100
RP/0/RSP0/CPU0:router(config-if)# lacp churn logging both
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
594
Link Bundling Commands on the Cisco ASR 9000 Series Router
Logs the churn events of the actor, which is the router under consideration,
only.
Logs the churn events of both the actor and the partner.
Logs the churn events of the partner router only
Modification
This command was introduced.
Operation
read, write