Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

Multilink Commands on the Cisco ASR 9000 Series Router
Examples The following example shows how to enable frame relay encapsulation for a multilink bundle, and enter
subinterface configuration mode.
RP/0/RSP0/CPU0:routerRP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router# configure terminal
RP/0/RSP0/CPU0:router(config)# interface multilink 0/3/0/0/1
RP/0/RSP0/CPU0:router(config-if)#
RP/0/RSP0/CPU0:router(config-if)# exit
RP/0/RSP0/CPU0:router(config)#
RP/0/RSP0/CPU0:router(config-subif)#
The following example shows how to enter interface configuration mode for a multilink bundle with ppp
encapsulation. ppp encapsulation is the default encapsulation type:
RP/0/RSP0/CPU0:router# configure terminal
RP/0/RSP0/CPU0:router(config)# interface multilink 0/3/0/0/1
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
Command
show interfaces multilink, on page 690
interface multilink 0/3/0/0/1.1 point-to-point

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

encapsulation frame-relay
ipv4 address 10.86.10.48/24
ipv4 address 10.86.10.48/24
Description
Displays information about a multilink interface.
interface multilink
Release 5.3.x
681