Ssrp Group - Cisco ASR 9000 Series Command Reference Manual

PPP Commands onthe Cisco ASR 9000 Series Router

ssrp group

To attach an Session State Redundancy Protocol (SSRP) group on an interface, use the ssrp group command
in interface configuration mode. To remove the SSRP group from the interface, use the no form of this
command.
ssrp group group-number id id-number ppp
Syntax Description
group-number
id id-number
ppp
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The group must be configured first on a specific location (linecard) and then assigned to the interface. The
redundancy ID must be unique within the group. This command specifies a list the protocols that the group
can replicate. Currently only PPP is supported.
Task ID
Task ID
ppp
Examples The following example shows how to
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface Multilink 0/1/0/0/1
SSRP group number. The range is 1 to 65535.
SSRP identifier number. The range is 1 to 4294967295.
Specifies point-to-point protocol.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Operations
read, write
ssrp group
Release 5.3.x
771