Module Installation; Ethernet Port Connector; Figure 4: Rj-45 Connector - GE RX3i User Manual

CPE330 Ethernet LED Operation
LED LED State
LINK (upper)
1Gbps
(lower)
CPE400 Ethernet LED Operation (LAN1, LAN2, LAN3)
LED LED State
Link On Green
Status
Blinking
(upper)
Green
Off
Link
On Green
Speed
Off
(lower)

Module Installation

For general information about CPU module and system installation refer to the PACSystems RX3i System
Manual, GFK-2314 Chapters 2 & 3.

Ethernet Port Connector

2.2
The RX3i CPE305 and CPE310 CPUs provide a 10BaseT/100BaseTX
Ethernet network port connector.
Note: Although the CPE310 can be configured as a CPU310 for backward compatibility, an
Ethernet cable should not be connected to the device when it is configured as a CPU310.
Ethernet is not supported when CPE310 is configured as a CPU310 and the Ethernet port
should not be connected to any network as it may have adverse effects on the network
and/or operation of the CPU.
GFK-2224Q
Operating State
On Green The corresponding link is physically connected.
Blinking Traffic is detected at the corresponding port.
Green
Off No connection detected at corresponding port.
On Amber Corresponding network data speed is 1 Gbps.
(LAN1) or
On Green
(LAN2)
Off Corresponding network data speed is 100 Mbps or 10 Mbps.
Operating State
The corresponding link has been established.
Traffic is detected at the corresponding port.
No connection established at corresponding port.
Corresponding data speed is 1 Gbps or 100 Mbps.
Corresponding network data speed is 10 Mbps
Chapter 2. Installation and Start-up: RX3i Embedded Interface
January 2017

Figure 4: RJ-45 Connector

17