1.3 Installation
Figure 1-1 Installation of PMC Module
The PMC module is now ready for installation. Installation is done generically as
with the commercial versions of the card. Follow any specific procedures
recommended by the manufacturer of the chassis used. Perform the following
steps:
1. Turn all system power OFF.
2. Remove the host board from the chassis (if currently installed).
3. Locate the PMC connectors on the host board.
4. Carefully plug the PMC module into the mating connectors on the host's
printed circuit board.
5. Make sure the PMC module is seated properly into the common mezzanine
card (CMC) connectors on the host.
6. Use screws to fasten PMC to the host CMC.
7. Remove the four screws from the bottom of the stand‐offs of the PMC.
8. Line‐up the J1 and J2 connectors on the host CMC to the J1 and J2 connectors
on the PMC.
9. Ensure all connectors are properly aligned before pushing the connectors
together.
10. Use the four screws to connect the PMC stand‐offs to the host CMC.
11. The chassis may now be powered up.
Refer to the illustrated drawing below:
Handling and Installation 11