Video Input Connector [1; Video Layout Disabledisconnectedlocaloutputs - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction
Video Input Connector [1..2] PresentationSelection
Define how the video system will behave when you connect a presentation source to the
video input. In general, any input source can be used as a presentation source; normally,
the main camera will not be used as a presentation source.
If the video system is in standby mode, it will wake up when you connect a presentation
source. Sharing the presentation with the far end requires additional action (select Share on
the user interface) except when this setting is set to AutoShare.
Requires user role: ADMIN
Default value: Connector 1: Manual Connector 2: OnConnect
Value space: Manual/OnConnect
AutoShare: While in a call, the content on the video input will automatically be presented
to the far end as well as on the local screen when you connect the cable, or when the
source is activated otherwise (for example when a connected computer wakes up from
sleep mode). You do not have to select Share on the user interface. If a presentation
source is already connected when you make or answer a call, you have to manually
select Share on the user interface.
Desktop: The content on the video input will be presented on the screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). This applies both when idle and in a
call. Also, the content on the video input will stay on the screen when you leave the call,
provided that it was the active input at the time of leaving.
Manual: The content on the video input will not be presented on the screen until you
select Share from the user interface.
OnConnect: The content on the video input will be presented on screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). Otherwise, the behavior is the same
as in manual mode.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals Maintenance
Video Input Connector [1..2] RGBQuantizationRange
The devices connected to the video input should follow the rules for RGB video quantization
range defined in CEA-861. Unfortunately some devices do not follow the standard and this
configuration may be used to override the settings to get a perfect image with any source.
Requires user role: ADMIN
Default value: Connector 1: Auto Connector 2: Full
Value space: Auto/Full/Limited
Auto: RGB quantization range is automatically selected based on video format according
to CEA-861-E. CE video formats will use limited quantization range levels. IT video
formats will use full quantization range levels.
Full: Full quantization range. The R, G, B quantization range includes all code values (0 -
255). This is defined in CEA-861-E.
Limited: Limited Quantization Range. R, G, B quantization range that excludes some code
values at the extremes (16 - 235). This is defined in CEA-861-E.
Video Input Connector [1..2] Visibility
Define the visibility of the video input connector in the menus on the user interface.
Requires user role: ADMIN
Default value: Connector 1: IfSignal Connector 2: Always
Value space: Never/Always/IfSignal
Never: When the input source is not expected to be used as a presentation source, set
to Never.
Always: When set to Always, the menu selection for the video input connector will
always be visible on the graphical user interface.
IfSignal: When set to IfSignal, the menu selection for the video input connector will only
be visible when something is connected to the video input.

Video Layout DisableDisconnectedLocalOutputs

This setting is fixed to On.
Default value: On
Value space: On
On: The built-in layout engine does only set layout on local outputs having a monitor
connected.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
134
Administrator Guide
System settings System settings Appendices