Cisco TelePresence SX20 Quick Set Administrator's Manual page 67

Cisco TelePresence SX20 Quick Set

Introduction
Factory reset the video system
Factory reset using the power button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
1. Press and hold the power button until the LED light goes out
completely and the system shuts down.
2. Press and hold the power button until the LEDs start blinking
slowly (approximately 10 seconds). Then release the button.
3. Within four seconds after the LEDs start blinking, press the
power button twice.
4. Wait while the video system reverts to the default factory
settings. The video system restarts automatically when
finished. This may take a few minutes.
The video system confirms the factory reset by displaying a
notification on the main screen. The notification disappears
after approximately 10 seconds.
If you failed to press the power button twice within the
four seconds, the system will not revert to the default
factory settings, and you will not see the confirmation
message. If this happens, go back to step 1 and try again.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals
(page 2 of 2)
Maintenance Maintenance
Power button with
LED indicator
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
67
Administrator Guide
System settings Appendices