Connect The Touch 10 Controller - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Connect the Touch 10 controller

In order to use Touch 10 as user interface for SX20, Touch 10 must
be paired to the codec via the network (LAN). This is referred to as
remote pairing.
Connect Touch 10 to the codec via the network
(LAN)
Connect Touch 10 and the codec to network wall sockets or to a
network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure begins.
Follow the instructions on screen.
When the Select a room system screen appears, note the following:
• A list of codecs signalling that they are available for paring will
show up on the screen. Tap the name of the codec you want to
pair with.
Note that the following must be fulfilled for a codec to show up in
the list:
• The codec and Touch 10 must be on the same subnet.
• The codec must have been restarted within the last 10
minutes. If the codec does not appear in the list, try restarting
it.
• If the codec does not appear in the list of available codecs, enter
its IP address or hostname in the input field. Tap
• You have to log in with username and passphrase for the paring
process to commence. Tap Login or Continue.
A user with the USER role is sufficient; you do not need the ADMIN
role to perform this task.
Read more about how to create a user account and assign a role
to it in the ► User administration chapter.
If Touch 10 needs software upgrade, new software will be downloaded
from the codec and installed on the unit automatically as part of the
set-up procedure. Touch 10 restarts after the upgrade.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals Peripherals
(page 1 of 2)
Power
• 100-240 VAC
• 50/60 Hz
Enter or Continue.
Maintenance
SWITCH
PoE
injector
AP
Contact information
The codec's name or
address is displayed
in the status bar when
Touch 10 is successfully
paired to the codec.
The Ethernet connector
is behind the lid at the
rear of Touch 10.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
54
Administrator Guide
System settings Appendices
Standard Ethernet cable
Network (LAN)
Standard Ethernet cable
Network (LAN)
PoE rated Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
1