Power On And Off - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction Introduction

Power On and Off

Power On/Off with the Power button
The power button is placed on the top lid as shown in the illustration. There is a ring of LEDs encircling the button.
Power button with
LED indicator
Switch on
If the codec does not start
automatically, press the power
button gently.
While starting up the LEDs are
lit. The light stops circling, and
the LEDs light steadily, when the
codec is ready for use.
D15329.03 SX20 Administrator Guide CE8.2, JUNE 2016.
Configuration Peripherals
Switch off
Press the power button gently
and hold until the light goes out
completely.
Maintenance
Enter/exit standby mode
Press the power button briefly.
It takes a few seconds before
the unit enters standby.
19
Administrator Guide
System settings
Power Off or restart the system remotely
Sign in to the web interface and navigate to
Restart.
Restart the system
Click Restart device... and confirm your choice.
It takes a few minutes before the system is ready for use.
Power Off the system
Click Shutdown device... and confirm your choice.
You cannot power On the system remotely.
Restart and standby using the remote
control or Touch controller
Restart the system
1. Select the settings icon (cogwheel) on the home
screen, or in the status bar of the Touch controller.
2. Select System Information > Restart
control, or Settings > Restart on the Touch controller.
3. Select Restart again to confirm your choice.
Enter/exit standby mode
1. Select the settings icon (cogwheel) on the home
screen, or in the status bar of the Touch controller.
2. Select Standby.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Appendices
Maintenance >
with the remote