Video Configuration; Xconfiguration Video Defaultmainsource; Xconfiguration Video Input Connector [1..2] Cameracontrol Mode; Xconfiguration Video Input Connector [2] Dvitype - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

Video configuration

xConfiguration Video DefaultMainSource

Define which video input source shall be used as the main video source.
Requires user role: ADMIN, USER
Default value: 1
USAGE:
xConfiguration Video DefaultMainSource:
where
: 1/2
DefaultMainSource
Set the source to be used as the main video source.

xConfiguration Video Input Connector [1..2] CameraControl Mode

Define whether the camera that is connected to this video input connector can be controlled or
not.
Note that camera control is not available for Connector 2 (DVI-I)
Requires user role: ADMIN
Default value: Connector 1: On Connector 2: Off
USAGE:
xConfiguration Video Input Connector
where
: Unique ID that identifies the video input connector. Range: 1..2
n
: Connector 1: Off/On Connector 2: Off
Mode
Off: Disable camera control.
On: Enable camera control.
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xConfiguration
DefaultMainSource
n CameraControl Mode: Mode
xCommand
xConfiguration Video Input Connector [1..2] CameraControl CameraId
The camera ID is a unique identifier of the cameras that are connected to the video input.
Requires user role: ADMIN
Default value: 1
USAGE:
xConfiguration Video Input Connector
where
: Unique ID that identifies the video input connector. Range: 1..2
n
: 1
CameraId
The camera ID is fixed and cannot be changed.

xConfiguration Video Input Connector [2] DviType

The official DVI standard supports both digital and analog signals. In most cases the default
AutoDetect setting can detect whether the signal is analog RGB or digital. However, in some
rare cases when DVI-I cables are used (these cables can carry both the analog and digital
signals) the auto detection fails. This setting makes it possible to override the AutoDetect and
select the correct DVI video input.
Requires user role: ADMIN
Default value: AutoDetect
USAGE:
xConfiguration Video Input Connector
where
: AutoDetect/Digital/AnalogRGB/AnalogYPbPr
DviType
AutoDetect: Set to AutoDetect to automatically detect if the signal is analog RGB or
digital.
Digital: Set to Digital to force the DVI video input to Digital when using DVI-I cables with
both analog and digital pins and AutoDetect fails.
AnalogRGB: Set to AnalogRGB to force the DVI video input to AnalogRGB when using
DVI-I cables with both analog and digital pins and AutoDetect fails.
AnalogYPbPr: Set to AnalogYPbPr to force the DVI video input to AnalogYPbPr, as the
component (YPbPr) signal cannot be auto detected.
98
API Reference Guide
xStatus Appendices
n CameraControl CameraId: CameraId
n DviType: DviType
Copyright © 2017 Cisco Systems, Inc. All rights reserved.