Removing A 3.5-Inch Hdd Module; Installing A 3.5-Inch Hdd Module; Concluding Steps; Replacing A 3.5-Inch Hdd Sas Backplane - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
state using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide.

7.3.11.2 Removing a 3.5-inch HDD module

Ê Remove the HDD module to be replaced from the server as described in
section "Removing a 3.5-inch HDD module" on page

7.3.11.3 Installing a 3.5-inch HDD module

Ê Install the new HDD module as described in section
modules" on page

7.3.11.4 Concluding steps

Ê When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page
"Performing a RAID array rebuild" on page 137
Ê

7.3.12 Replacing a 3.5-inch HDD SAS backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

7.3.12.1 Preliminary steps

"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê Remove all HDD modules as described in section
modules" on page
TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
218.
220.
Upgrade and Maintenance Manual
221.
"Installing 3.5-inch HDD
Hardware: 15 minutes
"Removing 3.5-inch HDD
83.
223