Removing The Ufm; Preliminary Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Ê Download the desired ESXi Recovery CD ISO image, listed under Tools.
Ê Unpack and burn the image to a CD.
Ê Ensure that no other USB storage device is connected to the server beside
the UFM.
Ê Insert the Recovery Tools CD into your CD/DVD drive and reboot the server.
The server should now boot from the Recovery Tools CD.
Ê Follow the on-screen instructions to initiate the installation.
After the flash process is complete, you will be asked to reboot the system.

14.3.2 Removing the UFM

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH1 / (+) No. 1 screw driver

14.3.2.1 Preliminary steps

"Suspending BitLocker functionality" on page 111
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê If applicable, remove an expansion card in slot 1 as described in section
"Removing expansion cards from standard slots" on page
TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
300.
457