Connecting Cables To The Sas Backplane 2; Concluding Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

7.3.13.7 Connecting cables to the SAS backplane 2

Figure 150: Connecting cables to the SAS backplane 2
Ê Connect the SAS cable to the backplane 2:
– (1) from SAS controller connector MLC2 to backplane 2 connector X9
Ê Connect power cables to the backplane 2:
– (2) power cable from system board connector PWR 12V 2 to the
backplane 2 connector X40
– (3) if applicable, power cable to an additional accessible drive (power
connector X17 or X18)
Ê If applicable, connect the OOB cable (see cabling plan in
page 530 or figure 402 on page
I
For a complete cabling overview, please refer to section
on page 512.

7.3.13.8 Concluding steps

"Installing the system fan holder" on page 94
Ê
"Installing the system air duct" on page 92
Ê
TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
530).
Upgrade and Maintenance Manual
figure 401 on
"Cabling plans"
235