Terminal Identification - GE MI-869 Instruction Manual

ELECTRICAL INSTALLATION

Terminal Identification

CAUTION:
NOTE:
NOTE
1
2–12
All the terminal strips are labeled with a slot letter to identify the module slot position and
numbers to identify the terminals within the module.
Make sure that the first letter on the terminal strip corresponds to the slot location
identified on the chassis silkscreen.
Terminal Connections
When installing two lugs on one terminal, both lugs must be "right side up" as shown in the
picture below. This is to ensure the adjacent lower terminal block does not interfere with
the lug body.
Figure 2-14: Orient the Lugs Correctly
2
Figure 2-15: Correct Installation Method
3 WASHER
TERMI AL
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION
SCREW
LOWER
TERMI AL
BLOCK
DIVIDER