Table of Contents
Advertisement
SOFTWARE INTERFACE
Loading Setpoints
from a File
CAUTION:
3–28
3.
The Print/Export Options dialog box appears. Select Setpoints in the upper section
and select either Include All Features (for a complete list) or Include Only Enabled
Features (for a list of only those features which are currently used) in the filtering
section and click OK.
4.
Setpoint lists can be printed in the same manner by right clicking on the desired file (in
the file list) or device (in the device list) and selecting the Print Device Information or
Print Settings File options.
An error message occurs when attempting to upload a setpoint file with a revision
number that does not match the relay firmware. If the firmware has been upgraded
since saving the setpoint file, see Upgrading Setpoints Files to a New Revision for
instructions on changing the revision number of a setpoint file.
The following procedure illustrates how to load setpoints from a file. Before loading a
setpoints file, it must first be added to the 869 environment as described in the section,
Adding Setpoints Files to the Environment.
1.
Select the previously saved setpoints file from the File pane of the 869 software main
window.
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES
Advertisement
Table of Contents
