8-Way And 16-Way Ac To Dc Power Supply Unit Upgrade To 100W - Honeywell 5704 Operating Instructions Manual

MAN0448_Issue 13_01-2010
005704-M-5001 A03249
CHAPTER 4 - INSTAllATION INSTRUCTIONS
Front View
50W Switched Mode AC to DC
Top View
50W Switched Mode AC to DC
Rear View
Input AC
Supply Voltage
16-Way AC to DC Power Supply Unit (200W)
17.2 8-Way and 16-Way AC to DC Power Supply Unit Upgrade
to 100W
To upgrade the 8-Way or 16-Way AC to DC Power Supply Units to
100W proceed as follows:
(1) Remove and retain the screws securing the top cover of the power
supply unit and lift the cover clear.
(2) Cut and remove the retaining straps that secure the unused ac and
dc connecting cables to the sub-unit chassis.
(3) On the 50W Switched Mode Module to be added to the 50W Sub-
Unit, remove and discard the four packing screws from the underside
of the module, however, retain the long nuts and washers.
(4) On the 50W Switched Mode Module to be added to the 50W Sub-
Unit, ensure that the spacers under the printed circuit board are
correctly located.
Power Supply Module
Power Supply Module
24V 100W
DC Output
Earth
Stud
4-56
5704 Control System
50W Switched Mode AC to DC
Power Supply Module
50W Switched Mode AC to DC
Power Supply Module
Input AC
24V 100W
Supply Voltage
DC Output
Earth
Stud