13.2 Analogue Output - Honeywell 5704 Operating Instructions Manual

MAN0448_Issue 13_01-2010
005704-M-5001 A03249
CHAPTER 4 - INSTAllATION INSTRUCTIONS

13.2 Analogue Output

Analogue Output Modules, when fitted, plug into the Four Channel
Control Card as shown below:
Plug-in Sockets for Analogue Output Modules:
04200-A-0145 Sink
04200-A-0146 Source
(From left to right
Connecting the analogue output to a loop voltage in excess of 40V
may cause permanent damage to the analogue output module.
The Analogue Output Modules provides a current loop output that
follows each sensor signal level. The loop output is isolated from the
control card supply and provides:
a. fully isolated operation per card when powered from an external
supply.
b. Non-isolated operation when powered from the System 57 power
supply.
The analogue outputs can be configured for 0 - 20mA or 4 - 20mA
output modes. Check the configuration sheet supplied with the system
- Channel 1 2 3 4)
CAUTION
4-42
5704 Control System