Honeywell 5704 Operating Instructions Manual page 168

MAN0448_Issue 13_01-2010
005704-M-5001 A03249
CHAPTER 7 - ENGINEER'S OPERATING
INSTRUCTIONS
(5) Push the Engineering Card CLOCK push-button a third time and
the selected control card will display:
a. The year (eg. 1995) on the message display
(flashing).
b. The month and day (eg. 08-26) or day and month
(eg. 26-08) on the digital display depending upon
the international date format configuration.
(6) Subsequent pushes of the ClOCK push-button will cause the month
and then the day to flash.
(7) Further pushes of the ClOCK push-button will repeat Steps (3) to
(6).
(8) At each stage, use the (
the displayed numerical value as required to set any new date and
time.
Note: Pressing the
will return the Engineering Card to the selected mode without
changing the clock time and calendar date.
(9) Press the push-button to set the Engineering Card real time clock
to the new date and time, and return the control card to the selected
mode.
13. MAINTENANCE RECORD PRINTOUTS
For details of the maintenance record printouts, refer to Chapter 6
Section 4.8.
) and ( ) push-buttons to raise or lower
push-button at any time during the above sequence
7-15
5704 Control System