Cameras Speakertrack Connectordetection Cameraleft; Cameras Speakertrack Connectordetection Mode; Cameras Speakertrack Mode; Cameras Speakertrack Trackingmode - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Cameras SpeakerTrack Mode

This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera.
The SpeakerTrack 60 camera assembly consists of two cameras and uses an audio tracking
technique that finds and captures a close-up of the active speaker. When a change of
speaker is detected, the system can switch automatically between the two cameras to
always show the best camera view. Refer to the Cameras SpeakerTrack TrackingMode
setting for different switching modes.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Off
Auto: Speaker tracking is switched on. The cameras in the camera assembly behave
as one integrated unit that finds the active speaker and dynamically chooses the best
camera view.
Off: The cameras operate as two individual cameras. Speaker tracking is not used.

Cameras SpeakerTrack TrackingMode

This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera, and
when Cameras SpeakerTrack Mode is set to Auto.
The speaker tracking algorithm can react to changes in two modes, one faster than the
other. The mode determines when the camera view will change to a new speaker.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Conservative
Auto: Normal tracking mode.
Conservative: The camera view will change to a new speaker later than in Normal mode.
D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016.
Configuration Peripherals Maintenance

Cameras SpeakerTrack ConnectorDetection Mode

This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected
to the codec (video system).
Define whether to automatically detect or manually configure which video input each
individual camera is connected to. You should choose manual configuration in situations
where the codec does not receive EDID information from the cameras. Typically, this will be
when you use HDMI repeaters that do not pass on EDID information.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Manual
Auto: Automatically detect which video inputs the cameras are connected to.
Manual: Manually define which video inputs the cameras are connected to. Use the
Cameras SpeakerTrack ConnectorDetection CameraLeft and Cameras SpeakerTrack
ConnectorDetection CameraRight settings.

Cameras SpeakerTrack ConnectorDetection CameraLeft

This setting applies only when a Cisco TelePresence SpeakerTrack 60 camera is connected
to the codec (video system). Furthermore, Cameras SpeakerTrack ConnectorDetection
Mode must be set to Manual.
Define the number of the video input that SpeakerTrack 60's left camera is connected to.
Requires user role: ADMIN, USER
Default value: 1
Value space: Integer (1..5)
Set a valid video input number. For example, set to 1 if the left camera is connected to
video input 1.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
100
Administrator Guide
System settings System settings Appendices