Honeywell EXPTZ-252A Installation&Operation Manual Book page 17

Honeywell
HWLKS-C-M-1918
Program and Operation
1.3 SCAN ( MENU => FUNCTION => SCAN or Shortcut: SCAN)
The Scan function supports up to 16 programmed section of angles at 8 programmable speeds
SCAN01:AUTOSCAN01 ~ SCAN08:AUTOSCAN08
SPEED(MODE) :
Follow the steps below to program Scans.
1.Press the SCAN key to enter Auto Scan menu directly. (or MENU => FUNCTION => SCAN).
2.Select an Auto Scan number by pushing the Joystick left or right.
3.Twist the Joystick to enter the title by scrolling through the alphanumeric characters and
pushing the handle to the right or left to move to the next space. Press ENTR key or push the
Joystick down to finish title mode.
4.Push the Joystick downward to select "SPEED" and set the speed by twisting the Joystick
clockwise or counterclockwise or moving the Joystick left/ right to select the auto scan speed.
5.When finish entering the title, select "START ANGLE" with the Joystick. Hold down the
SHFT/PGM key while selecting the start position using the Joystick. Current panning position will
be displayed. Release SHFT/PGM key to complete the selection of the start position. (Or twist zoom
handle or hit zoom button to start PTZ control for view selection and hit the Focus button to stop.)
6.Push the Joystick downward to select "END ANGLE." Hold down the SHFT/PGM key while
moving the Joystick to select the end position. The end position angle should be larger than start
position. Release the SHFT/PGM key to complete the selection of the end position.
zoom handle or hit zoom button to start PTZ control for view selection and hit the Focus button to
stop.)
7.Push the Joystick downward to select "DIR." Set the scan direction by moving the Joystick
left and right to select the auto scan direction.(CW or CCW)
SCAN MENU
SCAN 01 : AUTOSCAN01
SPEED : 1~8/SLW/MID
START : 127.1, 027.0 zoom
END : 157.7, 080.7 zoom
DIR. : CCW (PAN:000.0)
SWAP : OFF
SAVE AND EXIT
1/ 2 / 3/ 4/ 5/ 6/ 7/ 8/ SLOW / MEDIUM
1: SLOWER ↔ 8 FASTER
SLW : smooth Diagonal Scan in slowest speed
MID : smooth Diagonal Scan in medium speed
Diagonal Scan shows moving path from start point to
end point including tilt and zoom simultaneously.
01/08
- 17 -
.
(Or twist