Selecting A New Setting From A List Of Choices - Honeywell stt850 SMARTLINE User Manual

Install Date
DD MM YYYY
(HART only)
Display
Firmware Electronics
Sensor
Protocol HART, DE, FF
Model Key
(HART/FF)
<Exit Menu>

4.1.7 Selecting a new setting from a list of choices

Use the procedure described below to select a new setting for parameters that present a list of choices
(e.g., PV Display, Temperature Units, etc.)

1. Press to begin the edit process. The Basic Display will show the current setting of the item
on the lower line, left justified.
2. Press the  or  buttons to scroll through the list of choices.

3. Press to make your selection. The new selection will be stored in the transmitter and
displayed on the lower line, right justified.
Page 42
STT850 Temperature Transmitter User's Manual
This selection allows the user to enter
the date a transmitter is installed.
The Install Date is entered in
sequence of Day, Month, and Year,
followed by the new date and the
prompt Write Date to confirm the
entry.
CAUTION: The Install Date can only
be written once in the life of the
Transmitter. You cannot erase or
overwrite the Install Date once it has
been written.
Menu item shows the current
Firmware versions of the Display,
Electronics Module and the Sensor
Module
Menu item shows the
communications protocol
Identifies the type and range of the
transmitter
↑ and ↓ to
select
entry.
↵ to enter
Read Only
Parameter
Read Only
Parameter
Read Only
Parameter
Revision 3