Editing A Numeric Value; Selecting A New Setting From A List Of Choices; The Display Menus; Table 13 - Display Main Menu Structure - Honeywell SMV800 SmartLine User Manual

9.2.3 Editing a Numeric Value

Editing of a numeric value is a digit-by-digit process, starting with the left-most digit.

1. Press to begin the edit process.
2. The Display will show the current value of the item in a pop-up window in the middle of
the screen
3. Press the  or  buttons to select the desired digit, and then press
digit to the right.
After the last digit has been entered, press  one more time to write the new value to the
transmitter.

9.2.4 Selecting a new setting from a list of choices

Use the procedure described below to select a new setting for parameters that present a list of
choices (e.g., Screen Format, Display Units, etc.).
1. Press  to begin the edit process. The display will show the current setting of the item in a
pop-up window.
2. Press the  or  buttons to scroll through the list of choices.
3. Press  to make your selection. The new selection will be stored in the transmitter and will
be displayed on the lower line, right justified.

9.2.5 The Display Menus

The Display menus are organized into three levels, as shown by Table
There is a <Return> menu item at each level that allows the user to return to the previous level.
Key:
Parameters in Italics are read-only.
* HART only
** HART and DE
*** HART and Modbus
Level 1
<Exit>
Diagnostics
Display Setup
Page 34
Table 13 – Display Main Menu Structure
Level 2
n/a
Critical
Non-Critical
LCD Contrast
Common Setup
Screen 1
...
Screen 8
SMV800 Transmitter User's Manual
Level 3
n/a
For details go to the Diagnostics Menu table
For details go to the Display Setup Menu table.
Note that the Display supports the configuration
of up to 8 different screens.

to advance to the next
13.
Revision 10