Setting Tx Power; Tx Power Setting - Honeywell OneWireless XYR 6000 Professional Installation Manual

8. Setting TX Power

8.1 TX Power Setting

WARNING!
•
The XYR 6000 Transmitter must be Professionally Installed in accordance with
the requirements specified in this document. Only the specified power settings,
antenna types and gains and cable lengths (attenuation) as outlined in this
document are valid for XYR 6000 Transmitter installations.
The XYR 6000 as shipped from the factory will have its TX Power value set according to its Model
Number and this value is consistent with those values given in
The TX Power setting may be changed via the Authentication Device or Provisioning Device when a
special application (app) is installed. This app is considered to be Honeywell sensitive material and is
made available only to the qualified Professional Installer. Due to radio approval body regulations,
changing the TX Power setting is only available if the professional installer option has been explicitly
enabled on your Authentication Device or Provisioning Device. If you do not have the professional
installer option enabled and would like to do so, then please contact Honeywell Global Technical Services
(GTS). A separate application, AuthDev Power Settings, is required to enable the "Write TX Power
Level" option.
When this app is installed in the AD, the XYR 6000 TX power setting, normally a read-only parameter,
becomes a read/write parameter.
The TX Power adjustment feature is provided for Professional Installers to adjust the XYR 6000 TX power
to match a change in the selection of antenna and cables made at the installation site and still ensure that
the EIRP does not exceed the regulatory limits.
WARNING!
•
Japan does not allow the installer to change the TX Power setting. For this
reason, the special AD app is not available for installations in Japan.
Revision 3 OneWireless XYR 6000 Transmitter Professional Installation Guide
September 2012
8. Setting TX Power
8.1. TX Power Setting
Table 7-3 and Table 7-4.
25