Table 2-5 Mounting Procedure; Figure 2-4 Mounting Method - Honeywell UDC2300 Product Manual

Installation
Mounting Method
Before mounting the controller, refer to the nameplate on the outside of the case and
make a note of the model number. It will help later when selecting the proper wiring
configuration.
Mounting Procedure
Step
Mark and cut out the controller hole in the panel according to the dimension information
1
in Figure 2-3.
2 Remove the screw cover and loosen the screw on the front of the controller. Pull the
chassis out of the case.
3 Orient the case properly and slide it through the panel hole from the front.
4
Remove the mounting kit from the shipping container and install the kit as follows:
•
Install the screws into the threaded holes of the clips.
•
Insert the prongs of the clips into the two holes in the top and bottom of the case.
•
Tighten both screws to secure the case against the panel.
•
Carefully slide the chassis assembly into the case, press to close, and tighten the
screw. Replace the screw cover.
10
Panel

Figure 2-4 Mounting Method

Table 2-5 Mounting Procedure

UDC2300 Limit Controller Product Manual
20752
Action
1/01