Initial Start-Up; Overview; Powering Up The Controller - Honeywell UDC2300 Product Manual

3.1 Overview

This section gives you the information necessary to start up your controller prior to
configuration. Review the Operator Interface portion to make sure you are familiar with
the indicator definitions and key functions.

3.2 Powering Up the Controller

Apply Power
When power is applied, the controller will run three diagnostic tests. After these tests are
completed, "TEST DONE" is displayed.
Test Failures
If one or more of these tests fail, a message indicating which test failed will appear in the
lower display. Then, "DONE" will appear in the lower display.
1/01

3 Initial Start-up

UDC2300 Limit Controller Product Manual
Initial Start-up
19