Table 1-11 Kcm 805 Configuration Module; Table 1-12 Ka 815/Ka 92 Antennas - Honeywell KMH 880 Installation Manual

B
1.5.2 Configuration Module
The Configuration Module contains two EEPROMs, one for the TAS Processor
and one for the EGPWS.
The Configuration Module will be remotely mounted in the airframe. It will be
mapped with the Configuration at the installation of the system. An external PC
program will be available to the installer to initialize/program the configuration
module. Reference this Install Manual,
dures. A system failure will be annunciated if the configuration module is not pro-
grammed, not compatable with the current TAS processor software or if the CRC
read from the module is incorrect.
SYSTEM MANUFACTURER/
COMPONENT MODEL DESIGNER
Configuration Bendix/King
Module KCM 805
1.5.3 Antennas
Full bearing coverage will be achieved by the use of a top and bottom directional
antenna system. The TAS Processor will also be capable of supporting a top
directional and bottom monopole antenna configuration. In the latter configuration,
only intruders being tracked via the top directional antenna will have bearing infor-
mation.
The antennas will be vertically polarized and cover 360 degrees in azimuth and at
least -10 to +20 degrees in elevation.
SYSTEM
COMPONENT MODEL DESIGNER
Directional Bendix/King
Antenna KA 815
GPS Antenna Bendix/King
KA 92
Omni-Directional Dorne and Margolin
Antenna Dayton Granger
Sensor System
Comat Industries
Rev 3, August/2002
DESCRIPTION
Configuration Module

Table 1-11 KCM 805 Configuration Module

MANUFACTURER/
TAS Directional
Antenna
GPS Antenna
L-Band Antenna

Table 1-12 KA 815/KA 92 Antennas

10609I03.CDL
Section IV for the programming proce-
PART NUMBER
071-00112-0100
DESCRIPTION PART NUMBER
071-01599-0100
071-01553-0200
DM NI50-9-2*
10-611-10
565-5366
CI 310
KMH 880/KTA 870
TSO COMPLIANCE
TSO C147 Class A
TSO C151a Class B
TSO
COMPLIANCE
TSO C147
Class A
TSO C129
TSO C66a
TSO C74
Page 1-13