Table of Contents
Advertisement
B
To begin the
Bore
4.3.3, Paragraph E
Sight Bottom Antenna" from the "Config Mod" menu. Select the "Ramp Tester with a
target altitude at 50,000" radio button and click OK. The test will take a few seconds
to complete. The test is successful if "Antenna Calculations Complete" is displayed
in the pop-up message box. Click OK to close the message box. If an error is
reported, refer to
Bore Sight procedure is successfully completed, the Delta 1 and Delta 2 offsets for
the selected antenna will be stored in the configuration module. TAS will automati-
cally shut down and restart after the test has been completed to begin using the
new antenna offsets.
8. Intruder Data
There are two options for viewing tracked intruder data ( currently under TAS sur-
veillance ). Overwrite View and Capture View ( see Figure 7).
Rev 3, August/2002
Sight procedure, set up the ramp tester as described in
(8), of this manual and select "Bore Sight Top Antenna" or "Bore
Section 4
of this manual for troubleshooting techniques. When the
Figure 7 Intruder Data Window
10609I03.CDL
KMH 880/KTA 870
Section
D-15
Advertisement
Table of Contents
