Chapter 3 Adjusting And Updating Settings As Required After Parts Replacement; If You Replace The Main Pcb Assy - Brother DCP-1510 Service Manual

CHAPTER 3 ADJUSTING AND UPDATING

1. IF YOU REPLACE THE MAIN PCB ASSY

2. IF YOU REPLACE THE LASER UNIT
3. IF YOU REPLACE THE DOCUMENT SCANNER UNIT OR CIS UNIT
4. IF YOU REPLACE THE LOW VOLTAGE POWER SUPPLY PCB UNIT
5. IF YOU REPLACE THE PANEL ASSY
1. IF YOU REPLACE THE MAIN PCB ASSY
<What to do after replacement>
• Installing main firmware
• Initializing the EEPROM of the main PCB ASSY (function code: 01)
• Setting by country (function code: 74)
• Installing language firmware (except for Chinese model)
• Setting serial number and entering adjusted value of laser unit
• Acquiring white level data (function code: 55)
• Setting language (function code: 52) (only for CEE model)
• Checking printing and scanning
What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (BrUsbsn.zip)
Copy this file into the temporary folder created on the C drive. Extract the copied file and
double-click "BrUsbsn.exe" to start it.
(4) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed on the computer, copy this file into the
temporary folder created on the C drive, and extract the copied file.
(6) Firmware
Main firmware
Language firmware
(E.g.) LZXXXX: First six digits of the part number of the firmware
SETTINGS AS REQUIRED AFTER
PARTS REPLACEMENT
(E.g.) LZXXXX_$.djf (firmware installation using computer)
$: Alphabetic character representing the revision version of the firmware
3-1
®
XP or later).
Confidential