Brother DCP-1510 Service Manual page 156

<Operating Procedure>
(1) Ten-key pad models
Press the [1] and [0] buttons in this order in the initial state of maintenance mode.
Non-ten-key pad models
Press the [ ] or [
[OK] button.
(2) "WSW00" is displayed on the LCD.
Ten-key pad models
Enter the worker switch number that you want to change the setting.
Non-ten-key pad models
Press the [ ] or [
the LCD and press the [OK] button.
(3) The display shown below appears on the LCD.
Selector No. 1
WSWXX = 0 0 0 0 0 0 0 0
Ten-key pad models
Press the [ ] or [
setting by pressing the [1] or [0] button.
Non-ten-key pad models
Press the [ ] or [
by pressing the [
(4) When changing the setting is completed, press the [OK] button. The new selector setting
value is stored in the EEPROM, and the LCD returns to the ready state for worker switch
number entry ([WSW00]).
(5) When worker switch setting is completed, press the [Stop/Exit] button to return the
machine to the initial state of maintenance mode.
Note:
• To cancel operation and return to the initial state of maintenance mode, press the
[Stop/Exit] button.
• After entering the first digit of the number, if there is no entry for one minute or longer on
the two digits firmware switch number selection, the machine returns to the initial state
of maintenance mode automatically.
] button to display "MAINTENANCE 10" on the LCD and press the
] button to display the worker switch number that you want to set on
Selector No. 8
] button to move the cursor to the desired selector, and change the
] button to move the cursor to the desired selector, and set the value
] or [ ] button.
4-12
Confidential