Chapter 4 Adjustments And Updating Of Settings, Required After Parts Replacement; If You Replace The Head/Carriage Unit Or Engine Unit - Brother DCPJ525W Service Manual

CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT
This chapter details adjustments and updating of settings, which are required if the head/carriage unit,
main PCB and some other parts have been replaced.
1

IF YOU REPLACE THE HEAD/CARRIAGE UNIT OR ENGINE UNIT

<Operations>
1.1 Update the head property data stored in the EEPROM on the main PCB*
1.2 Clean the new head/carriage unit (Function code 76)
1.3 Print out a nozzle test pattern (Function code 09)
1.4 Adjust the inclination of the head/carriage unit
1.5 Update the paper feeding correction value (Function code 58)
1.6 Align vertical print lines in monochrome (Function code 65)
1.7 Adjust margins in borderless printing (Function code 66)
1.8 Create head calibration data and write it into flash ROM (Function code 02)
1.9 Check the operation of the pressure roller (Function code 63)
1.10 Print out a total quality check pattern
1.11 Switch back to standby
1.12 Replace the ink cartridges with the protective part
1.13 Obtain machine information at the user site (Instruction to the end user)
<Requirements>
(1) USB cable (one piece)
(2) PC (Windows® XP/2000 or later)
(3) Service setting tool (BrUsbSn.exe)
(4) Download utility (FILEDG32.EXE)
(5) Maintenance driver (MaintenanceDriver.zip), if not installed
(6) Data files of print patterns
*Updating not required when the engine unit only is replaced
4-1
Confidential