Brother DCP-1510 Service Manual page 53

Error code 7D00
Jam Inside 3
Remove the jammed paper, then press Start.
When the power switch was turned ON, the eject sensor detected paper pass.
(Cannot determine whether the top cover is open or whether it is a paper jam.)
<User Check>
• Close the top cover.
• Remove the jammed paper.
Step
Eject actuator caught in
1
sections of the machine
Paper feed/paper printing
2
position sensor PCB failure
3 Eject sensor failure
4 Main PCB failure
Error code 7E00
Jam Tray
Remove the jammed paper from Tray, then press Start.
Detected that multiple paper is fed five times in a row during receiving fax or printing list/
report.
<User Check>
• Remove the jammed paper.
• Check that the paper is set in the paper tray correctly.
• Check that there is not too much paper set in the paper tray.
• Check that the thickness of the paper is within the standard.
• Check that the size of the paper is within the standard.
• Flip through the paper and reset it in the paper tray.
Step
1 Main PCB failure
Cause
Reattach the eject actuator.
Replace the paper feed/paper printing position
sensor PCB ASSY.
Replace the eject sensor PCB ASSY.
Replace the main PCB ASSY.
Cause
Replace the main PCB ASSY.
1-36
Remedy
Remedy
Confidential