7.13 Fuser unit
WARNING:
• Some parts inside the machine are extremely hot immediately after the machine is used.
When opening the top cover or back cover to access any parts inside the machine,
never touch the shaded parts shown in the following figures.
(1) Remove the two taptite pan B M4x14 screws.
(2) Release the center thermistor harness from the securing fixtures.
(3) Release the heater harness from the securing fixtures, and remove the fuser unit from the
machine.
(4) Remove the taptite pan B M3x8 screw, and remove the insulation roof from the fuser unit.
Taptite pan B M4x14
Center thermistor harness
Heater harness
Harness routing: Refer to
/ fuser
unit".
Insulation roof
Fig. 2-32
"1. Frame R / main PCB ASSY / low voltage power supply PCB unit
2-35
Taptite pan B M3x8
Taptite pan B M4x14
Fuser unit
Confidential