Details Of Maintenance Mode Functions; Initialize Eeprom Parameters (Function Code: 01, 91); Function Code; Initialize Eeprom Parameters - Brother DCP-1510 Service Manual

1.3

Details of Maintenance Mode Functions

1.3.1 Initialize EEPROM parameters (function code: 01, 91)

<Function>
This function is used to initialize the setting values for operation parameters, user switches,
and worker switches (WSW) registered in the EEPROM. Entering function code 01 initializes
most EEPROM areas. Entering function code 91 initializes only the specified areas as shown
in the table below.
Data item
Printer switch (counter information)
Error history
MAC address
Password for control panel operation lock
Secure function lock
Telephone function registration
Telephone directory
Worker switches
User switches (items initialized when
"Factory Reset" is executed)
Function settings except user switches
(settings not subject to "Factory Reset")
Emulation setting
<Operating Procedure>
(1) Ten-key pad models
Press the [0] and [1] buttons in this order in the initial state of maintenance mode (or
press the [9] and [1] buttons in this order as appropriate) to display "PARAMETER INIT"
on the LCD.
Non-ten-key pad models
Press the [
appropriate) on the LCD. Press the [OK] button. "PARAMETER INIT" is displayed on the
LCD.
(2) When initializing parameters is completed, the machine returns to the initial state of
maintenance mode.
Note:
• Function code 01 is for service personnel and function code 91 is for user support.
• When the power switch is turned OFF while "PARAMETER INIT" is displayed on the
LCD, initializing the EEPROM is not completed normally. In this case, when the power
switch is turned ON, the EEPROM is initialized automatically. When initialization is
completed, the machine returns to the initial state of maintenance mode.

Function code

] or [ ] button to display "MAINTENANCE 01" (or "MAINTENANCE 91" as
01
Areas not to be
initialized
Areas to be
initialized
4-4
91
Areas not to be
initialized
Areas to be
initialized
Confidential